Printable View
I have started to model the Halo 3 magnum.
I think it is look pretty good so far, in this thread i am ready for the flames and i will try and take them as helpful tips, but dont start saying stuff like "It is fucking shit", just say that it needs work or something.
The main part i have worked on is the back bit, ignore the front part, it needs loads of work.
Image 1 (Wireframe below image)
Image 2 (Wireframe below image)
Image 3 Screenshot
try actually having somethign to post before you post.
it's not fucking shit, it's just not much.
right now, all im seeing is a block with some extrusions, and booleans and chamfers.
improving over the old trash you used to produce though.
Ok, thanks tweek. I havnt used extrude much i added vertexes and then put them in place and stuff like that to get the shape i wanted.
So far though do you think its any good, because i want to know if my modeling is improving.
And ive added a bit of detail.
You can't really tell if it's good or not yet. You have barely showed anything.
its a decent start, it's a bit boring atm, since you're only becelling square stuff.
there's nothing goin on there, but you're improving.
but srsly, dont post this stuff when theres NOTHIGN to show.
try actually having somethign to show before you come to show it off
this is comparable with posting a box when you're at the point of box-modelling a tank or something.
Ok. Thanks tweek.
looks decent. finish the rest of the gun though.
Isn't the H3 magnum the same shape and color as the halo 1 pistol? <_<;
The nose of the gun (M6G) is a bit longer, tbh.
Also the magazine holds less rounds, and is accordingly smaller. The skinning is also somewhat different. It seems scratchier, a little bit lackluster.