Quote Originally Posted by Sever View Post
You need a front fender - that exhaust system is just way too exposed, especially with the driver's limited downwards field of view (which could also be fixed by trimming down the 'nose' on the front). Also, if you're going to have exposed (even if they are covered while the vehicle is in motion) electronics above the wheels, you should give the vehicle more protective wheel wells (to prevent flying debris from damaging the systems) and vertical coverings (to remove hazardous pinch points) along with proper steps and handles for whoever is using and servicing them. More steps and handles in general is a good idea on any vehicle - we use large trucks at my job, and it just sucks when it's harder than necessary to climb up to the cab or bed of the truck.
Currently this is just being block modeled. So yes, handles and stuff, should be added. At least I want to add some and also add detail to what's already been block modeled.
As far as the design goes, yea, your prob right, I would fix these flaws. Only thing is, this is going for my portfolio, and I was told to keep to a reference of choosing, as much as possible. This will help show that I can follow a certain concept. If not, it might look like I can't model accurately or I was not able to complete a certain area; hence the difference's.
I will take what you said into consideration though. I'll see what I'll do about it.
@ kid: Yup.